1. Home
  2. Knowledge Base
  3. Harvey Woodworking
  4. The belt on my Alpha HW110LC-36 is slipping. What can I do to fix it? What is causing this?

The belt on my Alpha HW110LC-36 is slipping. What can I do to fix it? What is causing this?

When receiving/ installing your Alpha HW110LC-36, you will be required to remove a yellow shipping bar. On this bar there is a bolt that controls the tension of the belt. If this bolt is not replaced, then the only thing tensioning the belt is the force of gravity. This would cause the belt to slip, and the saw won’t cut correctly. To fix this, please ensure that the bolt is properly in place, and tensioned correctly.

Updated on April 19, 2021

Was this article helpful?

Related Articles